INR18650-3000mAh Li-ion Rechargeable cylindrical battery
Model No.︰-
Brand Name︰Sunpower
Country of Origin︰China
Unit Price︰-
Minimum Order︰2000 pc
Product Description
INR18650-3000mAh Li-ion Rechargeable cylindrical battery,18650 battery,High security lithium ion battery,power tool lithium ion battery supplier
Safety Characteristic of car 18650 battery
|
NO. |
Item |
Standard |
Test Method |
|
1 |
Overcharge |
No fire、No explosion |
After standard charge, rest for 10mins; then charge at constant current of 3C to 10V.(or charge at 3C for90mins). |
|
2 |
Forced discharge |
No fire、No explosion |
The battery to be discharged with standard discharging condition, Inverse charge current =1C；time: ≥90mins |
|
|
Short Circuit test |
No fireNo explosion |
The battery to be fully charged with standard charging condition, and short the positive and negative terminals with wire resistance ≤50mΩ.Tests are to be conducted at 23℃±3℃ and at 55℃ ±5℃, keep 24h or casetemperature decline to 20% of the max temperature ,test is over. |
|
4 |
Crush test |
No fire/No explosion |
A battery is crushed between two flat surfaces. The applied force is 13 kN±1kN by hydrocylinder, Once the maximum pressure has been obtained or voltage decrease to 1/3 of nominal voltage sharply, then release pressure. |
|
5 |
Shock test |
No fire/No explosion |
The full charged battery is fixed on shock table, to force a certain shock to three mutual vertical direction, in initial3ms, the min. average acceleration is 75gn,the peak acceleration is between 125gn and 175gn. |
|
6 |
Heating test(130°C) |
No fire/No explosion |
The cells are fully charged with standard charging condition, and put into incubator with nature air or cycled air convected, heat battery by velocity of 5°C ±2°C/min to130°C±2°C,and maintain for 10mins. |
|
7 |
TemperatureCycling Test |
no leakage, no fire, no explosion |
The fully charged batteries are placed in a test chamber and subjected to the following cycles: a) Raising the temperature to 75°C ±2°C within 30 minutes and maintaining this temperature for 6 hours. b) Reducing the temperature to minus 40°C ±2°C within30 minutes and maintaining this temperature for 6 hours. c) Repeating the sequence for a further 9 cycles. d) Afterthe 10th cycle, storing the batteries for 24 hours prior to examination. |
Environment Adaptation Performance for 18650 lithium ion battery supplier
|
NO |
Item |
Standard |
Test Method |
|
1 |
Altitude/Low pressure simulation test |
no leakage, no fire, no explosion |
The full charged cells are to be stored for 6h at an vaccum environment with pressure of less than 11.6kPa and atemperature of 23℃±3℃. |
|
2 |
Free drop test |
no fire, no explosion |
The fully charged battery drops on the concrete ground from height(1m),total 3 times,to obtain the shock of random directions. |
|
3 |
Vibration test |
No remarkable damage、No smoking 、No explosion |
After standard charging, fixed the cell to vibration table and subjected to vibration cycling that the frequency is to be varied at the rate of 1Hz per minute between 10Hz and 55Hz,the excursion of the vibration is 1.52mm. The cell shall be vibrated for 90 minutes per axis of x, y axes |
Storage Temperature for Shipping
If the cell is kept as ex-factory status (50% of charge), the 0.2C recoverable capacity rate is more than 90%.
1 month -20°C ~ 60 °C
2 months-20°C ~ 40 °C
3 months-20℃~ 25 °C
Appearance
There shall be no such defect as deep scratch, flaw, crack, rust, leakage, which may adversely affect commercial value of the cell.
Package
The cells are packed with JIANGSU SUNPOWER CO.,LTD. standard carton box, which hold four inner boxes. There are 100pcs 18650 cells per inner box. And the inner box and outer box identifies battery capacity, voltage and impedance information.
Warranty Period & Product Liability for High security lithium ion battery
Warranty period of this product is 12 months from manufacturing code. JIANGSU SUNPOWER CO., LTD. is not responsible for the troubles caused by mishandling of the battery which is against the instructions in this specification.
Warnings and Cautions in Using the Battery
To prevent a possibility of the battery from leaking, heating or explosion please observe the following precautions:
● When using a new battery for the first time or after long term storage, please use the battery charger specifically for that purpose fully charge the battery before use.
● Do not disassemble or open, crush, bend or deform, puncture, or shred;
● Do not modify or remanufacture, attempt to insert foreign objects into the battery, immerse or expose to water or other liquids such as water, seawater, drinks such as soft drinks, juices, coffee or others, or expose to fire, explosion, or other hazard.
● Do not short circuit a battery or allow metallic or conductive objects to contact the battery terminals.
● Avoid dropping the phone or battery. If the phone or battery is dropped, especially on a hard surface, and the user suspects damage, take it to a service center for inspection.
● The battery replacement shall be done only by either cells supplier or device supplier and never be done by the user.
● Replace the battery only with another battery that has been qualified with the system per standard. Use of an unqualified battery may present a risk of fire, explosion, leakage, or other hazard.
● Don’t keep a battery at rest for a long time (over 6 months). Safety accident may happen when recharging battery which has a rest for a long time.
● In the event of a battery leak, do not allow the liquid to come in contact with the skin or eyes. If contact has been made, wash the affected area with large amounts of water and seek medical advice.
● Battery usage by children should be supervised. Seek medical advice immediately if a battery has been swallowed
● Never disassemble cells. The disassembling may generate internal short circuit in the cell, which may cause firing or other problems.
● Never incinerate nor dispose the cells in fire. These may cause firing of the cells, which is very dangerous and is prohibited.
● When use the battery , must to ensure the charge and discharge voltage of the battery is between 2.75V to 4.2V.
● Do not remove the outer sleeve from a battery pack nor cut into its housing.
● Do not mix our batteries with other battery brands or batteries of a different chemistry such as alkaline and zinc carbon.
● Do not mix new batteries in use with semi-used batteries, over-discharge may occur.
● Promptly dispose of used batteries in accordance with local regulations.
The company founded in 2014, focus on producing cylindrical power lithium-ion batteries. The company supply Electric vehicle cylindrical lithium battery, which include 1500mAh, 1300mAh, 2000mAh, 2200mAh, 2500mAh, 2600mAh Li-ion battery and 3000mAh Li-ion battery. All adopt the most advanced extrusion coating production technology and yearly production reaches to 250 million Ah power type 18650 High security lithium ion battery. Our products have high quality and competitive prices.
If you want to learn more about the High security lithium ion battery, please visit here.
https://www.sp-powerbattery.com/
More information:
http://www.newmadinaapparels.com
http://www.newvehicleaccessories.com
http://www.electricblogger.info
http://www.realestateblognet.com
http://www.integratedcaremanager.com
http://www.businesslistinc.com
http://www.growyourbusinesslist.com
Payment Terms︰ T/T, LC